OneWireViewer is a software development package for Dallas 1-Wire devices based on Java language, which supports different hardware and software platforms. It communicates using the 1-Wire protocol and provides adapters for serial, parallel, and USB ports.
This document introduces the DS1135L series products. The series products are low-power, 3V high-performance versions with three independent logic buffered delays. It can be used in standard 8-pin 118mil µSOP and 150mil 8-pin Mini-SO. The device features precise leading and trailing edge accuracy. It has the inherent reliability of an all-silicon delay line solution. Standard delay values are indicated in Table 1. Customers may contact Dallas Semiconductor at (972) 371-4348 for further information on custom delay values.
The DS1867 is a dual digital potentiometer with EEPROM from Texas Instruments. It operates on a single 5V or ±5V supply, has low power consumption, and maintains the position of the potentiometer in the absence of power. Two 256-position digital potentiometers can be read and written simultaneously via the serial port, and the resistors can be connected in series to increase the total resistance.
The DS1812 EconoReset is a 5V power reset chip released by Maxim. It has the characteristics of automatic reset, holding reset, precision temperature compensated voltage reference and voltage sensor.
DS1816 is a chip released by Maxim for detecting and recovering the microprocessor after power failure. This chip has the characteristics of automatic recovery, precision temperature compensation, reliable low power open drain output, etc.
This is the datasheet of DS1231/S power monitor chip. This chip can warn the processor of an impending power failure, provide an orderly shutdown time, and prevent the processor from destroying nonvolatile memory during power transients. It will also automatically restart the processor after power is restored. This chip is suitable for linear or switching power supplies and can adjust to the hold time of the power supply. It also supplies necessary signals for processor interface. This chip can accurately monitor 5% or 10% VCC and can replace power-up reset circuitry. It does not require external capacitors and is available in an optional 16-pin SOIC surface mount package.
The DS1811 EconoReset is a low-cost, high-precision power monitor IC that can detect power failures in a microprocessor system and automatically restart the microprocessor. It features a 5V open-drain output with an internal 5.5 kΩ pull-up resistor.
