TEXAS Manuals

This is a datasheet for SN5410, SN54LS10, SN54S10, SN7410, SN74LS10, SN74S10 triple 3-input positive-NAND gates

TPS732xx series is a NMOS switching type low dropout regulator produced by TI, with a 250mA output current, using SOT223 and SOT23 packages, supports 1.7V to 5.5V input voltage range, has 0.5% initial accuracy and 1% total accuracy, working current as low as 1µA, very suitable for portable applications.

The TPS736xx is a cap-free, NMOS, 400mA low-dropout regulator with reverse current protection. It uses a new topology that allows stable operation with or without output capacitors, including capacitors with low ESR. The TPS736xx features high reverse blockage, constant ground pin current, and low dropout voltage.

TMS320C6713 is the highest-performance floating-point digital signal processor (DSP) from Texas Instruments. It has a 32-bit instruction word width, 32/64-bit data width, and clock frequencies of 300-, 225-, 200-MHz (GDP), and 200-, 167-MHz (PYP). The chip features eight 32-bit instructions/cycle, a rich peripheral set, an optimized C/C++ compiler, and an advanced VLIW DSP core.

This document describes a 20-bit D-type flip-flop with 3-state outputs. It utilizes the Widebus family technology and features inputs that are compatible with TTL or CMOS voltage levels. It is suitable for high-speed layout and has high immunity to switching noise. The product consists of two 10-bit sections with separate control signals.

This document introduces UCC28521/28 combination PFC/PWM controllers, which provide complete control functionality for any off-line power system requiring compliance with the IEC1000−3−2 harmonic reduction requirements. By combining the control and drive signals for the PFC and the PWM stages into a single device, significant performance and cost benefits are gained. Based on the UCC28511, the new devices employ an average current mode control architecture with input voltage feedforward. The major difference of the UCC28521/28 is that it uses trailing-edge PFC and trailing-edge PWM modulation, which provides higher switching speed.

The PCM1739 is a digital-to-analog converter produced by Burr-Brown. It is manufactured using CMOS technology and supports 24-bit analog output. It supports 16-bit and 24-bit data and supports sampling rates of 10kHz to 192kHz.

The TSB82AA2B OHCI-Lynx™ Controller is a discrete 1394b link-layer device that provides the functionality of a single-chip 1394b OHCI controller and 1394b peripheral bridge.

This document describes the features and characteristics of the SN54F243 and SN74F243 quadruple bus transceivers. These transceivers are designed for asynchronous communication between data buses and offer flexible timing. They allow data transmission from the A bus to the B bus or from the B bus to the A bus based on the logic levels at the output-enable (OEBA and OEAB) inputs. The output-enable inputs can be used to disable the device, effectively isolating the buses. The dual-enable configuration allows the quadruple bus transceivers to store data by simultaneously enabling OEBA and OEAB. In this configuration, each output reinforces its input. Therefore, when both control inputs are enabled and all other data sources to the two sets of bus lines are in a high-impedance state, both sets of bus lines (eight in total) maintain their states. The 4-bit codes appearing on the two sets of buses will be identical for the ′F243. The SN54F243 is characterized for operation over the full military temperature range of -55°C to 125°C. The SN74F243 is characterized for...

The TPS2045A through TPS2048A and TPS2055A through TPS2058A power-distribution switches are intended for applications where heavy capacitive loads and short circuits are likely to be encountered. These devices incorporate 80-mΩ N-channel MOSFET high-side power switches for power-distribution systems that require multiple power switches in a single package. Each switch is controlled by an independent logic enable input. Gate drive is provided by an internal charge pump designed to control the power-switch rise times and fall times to minimize current surges during switching. The charge pump requires no external components and allows operation from supplies as low as 2.7 V. When the output load exceeds the current-limit threshold or a short is present, these devices limit the output current to a safe level by switching.

This is a low-power, high-gain amplifier that can be used in applications that require high gain and high output current.

The TPS771xx and TPS772xx are low-dropout regulators with integrated power-on reset and power good (PG) function respectively. These devices are capable of supplying 150 mA of output current with a dropout of 115 mV (TPS77133, TPS77233). Quiescent current is 92 µA at full load dropping down to 1 µA when device is disabled. These devices are optimized to be stable with a wide range of output capacitors including low ESR ceramic (10 µF) or low capacitance (1 µF) tantalum capacitors. These devices have ex- tremely low noise output performance (55 µVrms) without using any added filter capacitors. TPS771xx and TPS772xx are designed to have fast transient response and thermal shutdown protection.

This data sheet is about TL080, TL081, TL082, TL084, TL081A, TL082A, TL084A TL081B, TL082B, TL084B, TL082Y, TL084Y JFET-INPUT OPERATIONAL AMPLIFIERS.

The TIBPAL16L8-25C, TIBPAL16R4-25C, TIBPAL16R6-25C, TIBPAL16R8-25C TIBPAL16L8-30M, TIBPAL16R4-30M, TIBPAL16R6-30M, TIBPAL16R8-30M are low-power, high-performance IMPACT  PAL circuits that combine the latest Advanced Low-Power Schottky technology with proven titanium-tungsten fuses to provide reliable, high-performance substitutes for conventional TTL logic. These circuits are easy to program and can quickly design custom functions, typically resulting in a more compact circuit board. In addition, chip carriers are available for further reduction in board space. The TIBPAL16' C series is characterized by its high speed and functional equivalency, making it an ideal replacement for current available devices.

The TPS2045A through TPS2048A and TPS2055A through TPS2058A power-distribution switches are intended for applications where heavy capacitive loads and short circuits are likely to be encountered. These devices incorporate 80-mΩ N-channel MOSFET high-side power switches for power-distribution systems.