NXP NX5P1000 Logic Controlled High-Side Power Switch Datasheet

The NX5P1000 is an advanced power switch and ESD- protection device for USB OTG applications. The device includes under voltage and over voltage lockout, over-current, over-temperature, reverse bias and in-rush current protection circuits. These circuits are designed to isolate a VBUS OTG voltage source automatically from a VBUS interface pin when a fault condition occurs. The device features two power switch terminals, one input (VINT) and one output (VBUS). It has a current limit input (I


NXP NX5P1000 Logic Controlled High-Side Power Switch Datasheet - cover page
Brand
NXP
Category
power switch
Document type
Datasheet
Language
English
Pages
20
File format
PDF
File size
748 KB
Published
28 May, 2014
Updated
25 September, 2023
MD5 checksum
7B7EDF9C0378E4019FB61DA253247C21

About this manual

The NX5P1000 is a logic-controlled high-side power switch designed for USB On-The-Go (OTG) applications. It functions as an advanced power switch and electrostatic discharge (ESD) protection device, operating with a wide supply voltage range from 3 V to 5.5 V.

The device incorporates comprehensive protection circuits including under-voltage lockout, over-voltage lockout, over-current protection, reverse bias current protection, in-rush current protection, and over-temperature protection. It features two power switch terminals (VINT input and VBUS output) and includes a voltage detect output to monitor the interface pin status.

What's inside

  • General description
  • Features and benefits
  • Applications
  • Ordering information
  • Functional diagram
  • Pinning information
  • Pin description
  • Functional description

Specifications

Supply voltage range3 V to 5.5 V
VBUS tolerance30 V
Maximum continuous current (Isw)1 A
ON resistance (Rds(on))100 mQ maximum at 4.0 V
Low-power mode ground current20 uA typical
Control logic voltage1.8 V
Operating temperature range-40 °C to +85 °C

Frequently asked questions

What is the primary application for the NX5P1000?

The device is designed specifically for USB OTG applications.

What happens when the enable input (EN) is set LOW?

The device enters a low-power mode, disabling all protection circuits except the undervoltage lockout.

How does the over-current protection circuit reset?

The OCP circuit automatically resets when VINT > VBUS > VINT — 200 mV for 20 us.

Download PDF (748 KB)

More NXP Manuals


View all NXP manuals →