Operation and installation manual for the Pentair MiniMax NT Low NOx Series pool and spa heater, covering safety, installation, thermostat, and maintenance.
This operation and installation manual covers the Pentair MiniMax NT Low NOx Series pool and spa heater. The manual states that it applies to the MiniMax NT Low NOx 200, 250, 300, and 400 natural gas models and describes the heater as a compact, lightweight, induced-draft, gas-fired pool and spa heater that can be directly connected to schedule 40 PVC pipe.
The document includes safety rules, HSI lighting and operating instructions, electrical and gas installation guidance, thermostat programming, maintenance, troubleshooting, and a parts list. It also identifies Pentair Pool Products, Inc. as the contact for additional information.
| Models covered | 200, 250, 300 and 400 natural gas models |
|---|---|
| Power source | 120/240 V AC, 50/60 Hz |
| Electrical rating | 50/60 Hz, 120 V AC only |
| Ignition | Direct ignition (HSI); no standing pilot |
| Temperature controller | Pentair 7800 multifunction temperature controller |
| Maximum spa or hot tub water temperature | 104°F |
| Indoor vent adaptor kits | 4 in. kit P/N 460506; 5 in. kit P/N 460507 |
It covers the MiniMax NT Low NOx 200, 250, 300, and 400 natural gas models.
Do not try to light any appliance or touch an electrical switch. Call your gas supplier from a neighbor's phone, and if you cannot reach them, call the fire department.
Spa or hot tub water should never exceed 104°F; 100°F is considered safe for a healthy adult.
It uses a direct hot-surface ignition (HSI) device and does not need a standing pilot.