Fairchild application note AN-6982 describes the operation and step-by-step design of a continuous conduction mode power factor correction converter using…
This Chinese application note (AN-6982, Rev. 1.0.1, dated 11/26/14) is a Fairchild document about designing a power factor correction converter with the FAN6982 controller. It introduces the FAN6982 as a 14-pin continuous conduction mode (CCM) PFC controller IC that uses leading-edge modulation for current sharing and lists features such as variable output voltage (range function), RDY signal, TriFault Detect, PFC soft start, peak current limit, line feedforward, and input brownout protection.
The note explains CCM and BCM operation, the current and voltage control loops, line feedforward, line voltage sensing, the range function, the oscillator, the RDY function, and soft-start operation. It includes a typical application circuit and design equations for key parameters. This manual is written in Chinese.
| Device type | 14-pin continuous conduction mode (CCM) PFC controller IC |
|---|---|
| Control modulation | Leading-edge modulation for current sharing |
| Internal reference voltage | 2.5 V |
| Internal resistor RM | Typically 5.7 kΩ |
| PFC startup threshold | 1.9 V |
| Brownout protection trip point | 1.05 V |
| Range function current source | 20 µA |
| Soft-start VEA clamp | 2.8 V until PFC output reaches 96% of nominal |
It is a 14-pin continuous conduction mode (CCM) power factor correction (PFC) controller IC.
It lowers the PFC output voltage under light-load and low-line conditions.
It is typically used to control startup and shutdown of a downstream converter.
It is set by the timing resistor and capacitor on the RT/CT pin.