Installation guide for the Eaton Green Motion Home EV charger with wiring, Ethernet and safety instructions.
This guide provides step‑by‑step instructions for professional installers to mount, wire, and commission the Eaton Green Motion Home electric‑vehicle charger. It covers required tools, safety cautions, mechanical mounting, electrical connections, Ethernet setup, and commissioning procedures.
The manual also includes maintenance, troubleshooting, technical data, and warranty information, ensuring the charger is installed safely and operates within the specified environmental limits.
| Input voltage | 1 x 230 V (50 Hz) – 1 phase |
|---|---|
| Input current | 1 x 16 A (3.7 kW) – 1 phase |
| Output power | 3.7 kW to 22 kW |
| Output type | Type 2 cable or Socket (T2 or T2S) |
| Operating temperature | -25 °C to +45 °C |
| Weight | 3 kg (without cables) |
| Cable length | 5 meters |
| Degree of protection | IP54 |
| Impact strength | IK08 |
| Maximum altitude | Up to 2000 m |
The charger is rated for -25 °C to +45 °C operating temperature.
Open the charger housing, locate the LAN 1 Gbps port, and connect the RJ45 cable to the Ethernet port.
First disconnect any load, then open the housing by removing the fixing screws before proceeding with further steps.