Dell PowerEdge 1300 Systems EIDE Hard-Disk Drive Update
This document provides instructions for installing and using the enhanced integrated drive electronics (EIDE) hard-disk drives supported by the Dell PowerEdge 1300 system. It details how to configure the drives using the cable select jumper position and describes the physical installation process within the internal hard-disk drive cage.
| Supported Drive Size | 1-inch or 1.6-inch EIDE hard-disk drives |
|---|---|
| Maximum Drive Count | Two EIDE hard-disk drives |
| Connector Type | 40-pin IDE1 connector |
| Power Management Delay | About 20 minutes |
Devices are configured for the cable select jumper position, where the device on the last connector is the master (drive 0) and the middle connector is the slave (drive 1).
EIDE hard-disk drives should be connected to the EIDE interface connector labeled IDE1.