Dell PowerConnect 5500 Series Switch Getting Started Guide

The Dell PowerConnect 5500 Series switch is a high-performance, low-cost solution for small businesses and branch offices. The switch series offers a variety of port density and speed options to meet various network needs.


Dell PowerConnect 5500 Series Switch Getting Started Guide - cover page
Brand
DELL
Category
Network Switches
Document type
User Manual
Language
English
Pages
20
File format
PDF
File size
1.4 MB
Published
26 November, 2023
Updated
26 November, 2023
MD5 checksum
EF6D70573A56A6BA6DAA10E70C730149

About this manual

This Dell PowerConnect 5500 Series Getting Started Guide explains how to install and run the PowerConnect 5500 series switches, covering site preparation, unpacking, rack or flat-surface mounting, and power supply connections.

It also covers stacking switches with HDMI cables, unit ID assignment, and initial configuration through the terminal and the Dell Easy Setup Wizard, including SNMP management, user accounts, and management IP address setup.

What's inside

  • Installation
  • Site Preparation
  • Unpacking and Package Contents
  • Installing in a Rack
  • Installing on a Flat Surface
  • Connecting the Switch to Power Supplies
  • Stacking Switches
  • Unit ID Assignment
  • Configuring the Switch
  • Configuration Using the Setup Wizard

Specifications

Regulatory ModelsPowerConnect 5524, 5524P, 5548, 5548P
Rack Size48.26-cm (19-inch) equipment rack
Power Requirements100-240 VAC, 50-60 Hz outlet
Operating Temperature0 to 45ºC (32 to 113ºF)
Operating Humidity10% to 90%, non-condensing
Maximum Switches per StackUp to eight switches
Stacking PortsTwo HDMI 10G ports
Flat Surface Clearance5.08 cm (2 inches) on each side and 12.7 cm (5 inches) at the back
Setup Wizard Response Time60 seconds

Frequently asked questions

Which PowerConnect 5500 series models are covered by this guide?

The regulatory models listed are the PowerConnect 5524, 5524P, 5548, and 5548P, and the instructions are the same for all models.

How many switches can be included in a stack?

Up to eight switches are supported per stack. Every stack must have a Master unit and may have a Master Backup unit.

How are switches connected for stacking?

The switches use two HDMI 10G ports for stacking, with an HDMI cable running from the left-hand port of the upper switch to the right-hand port of the switch below it.

What can I do if I do not answer the Setup Wizard prompt?

If you do not respond within 60 seconds, the Setup Wizard automatically exits and the CLI console prompt appears, and the system continues with the default system configuration.

Download PDF (1.4 MB)

More DELL Manuals


View all DELL manuals →