DC575 is a quick evaluation circuit board for evaluating the LTC2410, a 24-bit high performance ∆Σ analog-to-digital converter. The device is available in a 16 pin GN package and has an easy to use SPI interface.
This document is a Quick Start Guide for the DC575 demonstration circuit, which features the LTC2410, a 24-bit high performance delta-sigma analog-to-digital converter (ADC). The guide describes the hardware setup, including connections to the DC590 USB Serial Controller and configuration of jumpers for reference voltage and trigger modes. It also details the analog connections for the differential inputs and ground planes.
| Linearity | 2ppm |
|---|---|
| Full-scale accuracy | 2.5ppm |
| Offset | 0.1ppm |
| Noise | 0.16ppm |
| Input common mode rejection | 140 dB |
| Package | 16 pin GN |
| Interface | SPI |
Connect DC575 to a DC590 USB Serial Controller using the supplied 14-conductor ribbon cable, then connect DC590 to the host PC with a standard USB A/B cable.
The default source for REF+ is 5.00 volts from the onboard LT1236 reference.
Solder a short wire from the IN- turret post to the IN+ turret post; the noise should be approximately 0.16ppm.