Yaskawa FS100 Error 9: A syntax error was found in the CNT instruction.

Yaskawa FS100 · taken from the manufacturer’s manual, pages cited

Alarm code9

A syntax error was found in the CNT instruction. The manual's first action is: “(1)Turn the power OFF then back ON. (2)If the alarm occurs again, initialize the appropriate data in maintenance mode, and then load the data saved in the external memory device.”

Model
Yaskawa FS100
Display shows
A syntax error was found in the CNT instruction. (9)
Type
Alarm code
Source
Manual p. 117

What 9 means

A syntax error was found in the CNT instruction. p. 117

Common causes

  • Data error p. 117
  • Software operation error occurred p. 117

What to do

  1. (1)Turn the power OFF then back ON. (2)If the alarm occurs again, initialize the appropriate data in maintenance mode, and then load the data saved in the external memory device. p. 117
  2. (1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 117
  3. (1)Reset the alarm., and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 117

Before you service the product, read the safety instructions in the manual p. 4.

If 9 is still not resolved

  • (1)Turn the power OFF then back ON. (2)If the alarm occurs again, initialize the appropriate data in maintenance mode, and then load the data saved in the external memory device. p. 117
    “(1)Turn the power OFF then back ON. (2)If the alarm occurs again, initialize the appropriate data in maintenance mode, and then load the data saved in the external memory device.”
Open the manual at page 117 All FS100 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 9; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.