Yaskawa FS100 Error 13: An error was found in the PART instruction.

Yaskawa FS100 · taken from the manufacturer’s manual, pages cited

Alarm code13

An error was found in the PART instruction. The manual's first action is: “(1)Turn the power OFF then back ON. (2)If the alarm occurs again, initialize the appropriate data in maintenance mode, and then load the data saved in the external memory device.”

Model
Yaskawa FS100
Display shows
An error was found in the PART instruction. (13)
Type
Alarm code
Source
Manual p. 117

What 13 means

An error was found in the PART instruction. p. 117

Common causes

What to do

  1. (1)Turn the power OFF then back ON. (2)If the alarm occurs again, initialize the appropriate data in maintenance mode, and then load the data saved in the external memory device. p. 117

If 13 is still not resolved

  • (1)Turn the power OFF then back ON. (2)If the alarm occurs again, initialize the appropriate data in maintenance mode, and then load the data saved in the external memory device. p. 117
    “(1)Turn the power OFF then back ON. (2)If the alarm occurs again, initialize the appropriate data in maintenance mode, and then load the data saved in the external memory device.”
Open the manual at page 117 All FS100 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 13; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.