Yaskawa FS100 Error 8: The AND-STR instructions are overused.

Yaskawa FS100 · taken from the manufacturer’s manual, pages cited

Alarm code8

The AND-STR instructions are overused. The manual's first action is: “(1)Turn the power OFF then back ON. (2)If the alarm occurs again, initialize the appropriate data in maintenance mode, and then load the data saved in the external memory device.”

Model
Yaskawa FS100
Display shows
The AND-STR instructions are overused. (8)
Type
Alarm code
Source
Manual p. 117

What 8 means

The AND-STR instructions are overused. p. 117

Common causes

What to do

  1. (1)Turn the power OFF then back ON. (2)If the alarm occurs again, initialize the appropriate data in maintenance mode, and then load the data saved in the external memory device. p. 117
  2. (1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 117
  3. (1)Reset the alarm., and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 117
  4. (1)Check the following settings. -Perform the teaching again so that the 1staxis (elevation axis) positions of C3, C4, and C5 of station axes are not the same. p. 117

If 8 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Yaskawa service.

Open the manual at page 117 All FS100 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 8; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.