The head of the block starts with an instruction other than the STR instruction. The manual's first action is: “(1)Turn the power OFF then back ON. (2)If the alarm occurs again, initialize the appropriate data in maintenance mode, and then load the data saved in the external memory device.”
- Model
- Yaskawa FS100
- Display shows
- 10
- Type
- Alarm code
- Source
- Manual p. 117
What 10 means
The head of the block starts with an instruction other than the STR instruction. p. 117
Common causes
What to do
- (1)Turn the power OFF then back ON. (2)If the alarm occurs again, initialize the appropriate data in maintenance mode, and then load the data saved in the external memory device. p. 117
- (1)Turn the power OFF then back ON. (2)If the alarm occurs again, replace controller. Save the CMOS.BIN before replace controller to be safe. p. 117
- (1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 117
- (1)Reset the alarm., and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 117
If 10 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Yaskawa service.
This page summarises what the manufacturer’s manual says about 10; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.