Yaskawa FS100 Error 7: The specified A_BANK number does not exist.

Yaskawa FS100 · taken from the manufacturer’s manual, pages cited

Alarm code7

The specified A_BANK number does not exist. The manual's first action is: “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”

Model
Yaskawa FS100
Display shows
The specified A_BANK number does not exist. (7)
Type
Alarm code
Source
Manual p. 229

What 7 means

The specified A_BANK number does not exist. p. 229

Common causes

  • Software operation error occurred p. 229
  • Setting error p. 229

What to do

  1. (1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 229
  2. (1)Check the following settings. -Perform the teaching again so that the 1staxis (elevation axis) positions of C1, C2, and C3 of station axes are the same. p. 229

If 7 is still not resolved

  • (1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 229
    “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”
Open the manual at page 229 All FS100 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 7; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.