Yaskawa FS100 Error 6: A_BANK conversion could not be performed.

Yaskawa FS100 · taken from the manufacturer’s manual, pages cited

Alarm code6

A_BANK conversion could not be performed. The manual's first action is: “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”

Model
Yaskawa FS100
Display shows
A_BANK conversion could not be performed. (6)
Type
Alarm code
Source
Manual p. 229

What 6 means

A_BANK conversion could not be performed. p. 229

Common causes

  • Software operation error occurred p. 229
  • Setting error p. 229

What to do

  1. (1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 229
  2. (1)Reset the alarm., and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 229
  3. (1)Check the following settings. -Perform the teaching again so that the 1staxis rotation direction of C3, C4, and C5 of station axes are the same. p. 229

If 6 is still not resolved

  • (1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 229
    “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”
Open the manual at page 229 All FS100 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 6; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.