Alarm code4326
The system is running faster than allowed by settings. The manual's first action is: “Check the following settings. -Reduction in the motion speed”
- Model
- Yaskawa FS100
- Display shows
- OVER SPEED (4326)
- Type
- Alarm code
- Source
- Manual p. 222
What 4326 means
OVER SPEED p. 222
Common causes
- Setting error p. 222
- Connection failure p. 222
- Module failure (motor) p. 222
- Servo control board failure p. 222
What to do
- Check the following settings. -Reduction in the motion speed p. 222
- (1)Reset the alarm. (2)If the alarm occurs again, check that U-, V- and W-phase are appropriately connected. p. 222
- (1)Reset the alarm. (2)If the alarm occurs again, replace the motor. p. 222
- (1)Reset the alarm. (2)If the alarm occurs again, replace controller. Save the CMOS BIN before replace controller to be safe. p. 222
Before you service the product, read the safety instructions in the manual p. 4.
If 4326 is still not resolved
- Contact your service dealer for assistance. p. 222 “(1)Reset the alarm. (2)If the alarm occurs again, replace controller. Save the CMOS BIN before replace controller to be safe.”
This page summarises what the manufacturer’s manual says about 4326; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.