Yaskawa FS100 Error 4324: CONVERTER OVERLOAD – Meaning, Causes & Fix

Alarm code4324

The converter has overloaded due to incorrect settings or hardware failure. The manual's first action is: “Check the settings of the following. -If the tool or the workpiece used has exceeded the allowable load.”

Model: Yaskawa FS100
Display shows: CONVERTER OVERLOAD (4324)
Type: Alarm code
Source: Manual p. 222

Meaning
Common causes
What to do
Still not solved
Source

What 4324 means

CONVERTER OVERLOAD p. 222

Common causes

Setting error p. 222
Module failure (converter) p. 222

What to do

Check the settings of the following. -If the tool or the workpiece used has exceeded the allowable load. p. 222
Adjust the job speed. Adjust the acceleration/deceleration of ACC and DEC instructions. p. 222
(1)Reset the alarm. (2)If the alarm occurs again, replace controller. Save the CMOS BIN before replace controller to be safe. p. 222

If 4324 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Yaskawa service.

Open the manual at page 222 All FS100 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 4324; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.