Yaskawa FS100 Error 4310: ENCODER OVERHEAT

Yaskawa FS100 · taken from the manufacturer’s manual, pages cited

Alarm code4310

The encoder has overheated due to high temperature or internal failure. The manual's first action is: “Turn OFF the power supply for about 10 minutes.”

Model
Yaskawa FS100
Display shows
ENCODER OVERHEAT (4310)
Type
Alarm code
Source
Manual p. 217

What 4310 means

ENCODER OVERHEAT p. 217

Common causes

  • Overheated encoder p. 217
  • High ambient temperature p. 217
  • Module failure (encoder) p. 217

What to do

  1. Turn OFF the power supply for about 10 minutes. p. 217
  2. Adjust the ambient temperature to 40°C or less. p. 217
  3. (1)Reset the alarm (2)If the alarm occurs again, replace the encoder. p. 217

If 4310 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Yaskawa service.

Open the manual at page 217 All FS100 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 4310; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.