Error codeNoIGn
NoIGn indicates ignition failure, which may result from setting a lower Ito value or maintaining too large a torch stand-off distance before ignition. The manual's first action is: “Confirm the Fronius's manual”
- Model
- Yaskawa 2DX200
- Display shows
- NoIGn
- Type
- Error code
- Source
- Manual p. 51
What NoIGn means
Set a lower Ito value Keep the torch stand-off distance smaller before ignition. p. 51
Common causes
- Set a lower Ito value Keep the torch stand-off distance smaller before ignition. p. 51
Safety warnings — read before you start
- CAUTIONGeneral Safety Note. Some drawings in this manual are shown with the protective covers or shields removed for clarity. Be sure all covers and shields are replaced before operating this product. p. 2
- CAUTIONPre-Operation Inspection. Perform the following inspection procedures prior to conducting manipulator teaching. If problems are found, repair them immediately, and be sure that all other necessary processing has been performed. p. 5
- CAUTIONProgramming Pendant Handling. Always return the programming pendant to the hook on the DX200 cabinet after use. The programming pendant can be damaged if it is left in the manipulator’s work area, on the floor, or near fixtures. p. 5
What to do
- Confirm the Fronius's manual p. 51
If NoIGn is still not resolved
- If your copy of the manual is damaged or lost, contact a YASKAWA representative to order a new copy. p. 2 “If your copy of the manual is damaged or lost, contact a YASKAWA representative to order a new copy.”
This page summarises what the manufacturer’s manual says about NoIGn; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.