Yaskawa 2DX200 Error NoGAS: Check what volume of gas is still available

Industrial robot · taken from the manufacturer’s manual, pages cited

Error codeNoGAS

NoGAS indicates that gas volume is low, requiring verification of remaining gas supply. The manual's first action is: “Confirm the Fronius's manual”

Model
Yaskawa 2DX200
Display shows
Check what volume of gas is still available (NoGAS)
Type
Error code
Source
Manual p. 51

What NoGAS means

Check what volume of gas is still available p. 51

Common causes

  • Check what volume of gas is still available p. 51

Safety warnings — read before you start

  • CAUTIONGeneral Safety Note. Some drawings in this manual are shown with the protective covers or shields removed for clarity. Be sure all covers and shields are replaced before operating this product. p. 2
  • CAUTIONPre-Operation Inspection. Perform the following inspection procedures prior to conducting manipulator teaching. If problems are found, repair them immediately, and be sure that all other necessary processing has been performed. p. 5
  • CAUTIONProgramming Pendant Handling. Always return the programming pendant to the hook on the DX200 cabinet after use. The programming pendant can be damaged if it is left in the manipulator’s work area, on the floor, or near fixtures. p. 5

What to do

  1. Confirm the Fronius's manual p. 51

If NoGAS is still not resolved

  • If your copy of the manual is damaged or lost, contact a YASKAWA representative to order a new copy. p. 2
    “If your copy of the manual is damaged or lost, contact a YASKAWA representative to order a new copy.”
Open the manual at page 51 All 2DX200 error codes Manual details & download

This page summarises what the manufacturer’s manual says about NoGAS; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.