Err054 occurs when burn-back control is insufficient or wire stick is enabled; it can be resolved by increasing BBC or disabling "Wire stick". The manual's first action is: “Confirm the Fronius's manual”
- Model
- Yaskawa 2DX200
- Display shows
- Err054
- Type
- Error code
- Source
- Manual p. 51
What Err054 means
Increase the bbc (burn-back control) Switch off "Wire stick" in the set-up menu After the end of welding, make sure that the wire does not collide with the workpiece when the torch is retracted. p. 51
Common causes
- Increase the bbc (burn-back control) Switch off "Wire stick" in the set-up menu After the end of welding, make sure that the wire does not collide with the workpiece when the torch is retracted. p. 51
What to do
- Confirm the Fronius's manual p. 51
Before you service the product, read the safety instructions in the manual p. 2.
If Err054 is still not resolved
- If your copy of the manual is damaged or lost, contact a YASKAWA representative to order a new copy. p. 2 “If your copy of the manual is damaged or lost, contact a YASKAWA representative to order a new copy.”
This page summarises what the manufacturer’s manual says about Err054; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.