Error code50
Err050 indicates a main error code from the Fronius power source, with sub-code 50** showing specific details. The manual's first action is: “Disconnect NT60 or change/check NT24/UST/BPS/intermediate circuit capacitors Confirm the Fronius's manual”
- Model
- Yaskawa 2DX200
- Display shows
- Err050 (50)
- Type
- Error code
- Source
- Manual p. 50
What 50 means
Err050 p. 50
Common causes
- Sub code[50**] shows the error code of Fronius power source 50 :main error code ** :sub error code p. 50
Safety warnings — read before you start
- CAUTIONGeneral Safety Note. Some drawings in this manual are shown with the protective covers or shields removed for clarity. Be sure all covers and shields are replaced before operating this product. p. 2
- CAUTIONPre-Operation Inspection. Perform the following inspection procedures prior to conducting manipulator teaching. If problems are found, repair them immediately, and be sure that all other necessary processing has been performed. p. 5
- CAUTIONProgramming Pendant Handling. Always return the programming pendant to the hook on the DX200 cabinet after use. The programming pendant can be damaged if it is left in the manipulator’s work area, on the floor, or near fixtures. p. 5
What to do
- Disconnect NT60 or change/check NT24/UST/BPS/intermediate circuit capacitors Confirm the Fronius's manual p. 50
If 50 is still not resolved
- If your copy of the manual is damaged or lost, contact a YASKAWA representative to order a new copy. p. 2 “If your copy of the manual is damaged or lost, contact a YASKAWA representative to order a new copy.”
This page summarises what the manufacturer’s manual says about 50; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.