Shihlin Electric SDA Series Error AL. 03: Overcurrent

AC servo system · taken from the manufacturer’s manual, pages cited

Alarm codeAL. 03

AL.03 shows the main loop current exceeds 1.5 times the motor’s instantaneous maximum current. The manual's first action is: “Power OFF→ON”

Model
Shihlin Electric SDA Series
Display shows
Overcurrent (AL. 03)
Type
Alarm code
Source
Manual p. 198

What AL. 03 means

Overcurrent p. 229

Common causes

  • Main loop current value exceeds 1.5-fold of the instantaneous maximum current of the motor. p. 229

What to do

  1. Power OFF→ON p. 229
  2. Press SET at the current alarm screen p. 229
  3. Alarm reset (RES) signal p. 229

If AL. 03 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Shihlin Electric service.

This page summarises what the manufacturer’s manual says about AL. 03; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Shihlin Electric. Found a mistake? Report an error.