Shihlin Electric SDA Series Error AL. 0A: Serial communication overtime

AC servo system · taken from the manufacturer’s manual, pages cited

Alarm codeAL. 0A

AL.0A indicates no communication commands were received for too long or the overtime constant is improperly set. The manual's first action is: “Power OFF→ON”

Model
Shihlin Electric SDA Series
Display shows
Serial communication overtime (AL. 0A)
Type
Alarm code
Source
Manual p. 198

What AL. 0A means

Serial communication overtime p. 229

Common causes

  • Did not receive communication commands for a long time p. 229
  • Improper setup of the overtime constant p. 229

What to do

  1. Power OFF→ON p. 229
  2. Press SET at the current alarm screen p. 229
  3. Alarm reset (RES) signal p. 229
  4. Check if the communication line if broken or loosen. Change or renew the connection. p. 229
  5. Check the setup of the overtime constant. Set the values correctly. p. 229

If AL. 0A is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Shihlin Electric service.

This page summarises what the manufacturer’s manual says about AL. 0A; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Shihlin Electric. Found a mistake? Report an error.