Shihlin Electric SDA Series Error AL. 08: Over-large position control command

AC servo system · taken from the manufacturer’s manual, pages cited

Alarm codeAL. 08

AL.08 indicates a large position control command due to improper acceleration/deceleration, torque restriction, or gain setup. The manual's first action is: “Power OFF→ON”

Model
Shihlin Electric SDA Series
Display shows
Over-large position control command (AL. 08)
Type
Alarm code
Source
Manual p. 198

What AL. 08 means

Over-large position control command p. 229

Common causes

  • Incorrect setup of the acceleration / deceleration time parameter p. 229
  • Inproper torque restriction setup p. 229
  • Too small gain value setup p. 229
  • Too big external load p. 229
  • Position encoder wiring error p. 229
  • Loosen position encoder p. 229
  • Position encoder damaged p. 229
  • Poor position encoder wiring p. 229

What to do

  1. Power OFF→ON p. 229
  2. Press SET at the current alarm screen p. 229
  3. Alarm reset (RES) signal p. 229
  4. Check if the acceleration / deceleration time constant is too small. p. 229
  5. Check if the torque restriction parameter (PA05) is too small. p. 229
  6. Make sure if the position control gain value (PB07) is too small. p. 229
  7. Check external load. p. 229
  8. Make sure that he wiring follows the recommendation from the manual. Making correct wiring. p. 229
  9. Check if the position of the encoder connector. Re-installation p. 229
  10. Abnormal motor Motor replacement p. 229
  11. Check if the wiring has been loosen. Reconnect the wiring. p. 229

If AL. 08 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Shihlin Electric service.

This page summarises what the manufacturer’s manual says about AL. 08; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Shihlin Electric. Found a mistake? Report an error.