Rockwell Automation MicroLogix 1400 Error 0031: UNSUPPORTED INSTRUCTION DETECTED

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code0031

The program contains an instruction that the controller does not support. The manual's first action is: “['Modify the program so that the controller supports all instructions.', 'Recompile and reload the program and enter the Run mode.']”

Model
Rockwell Automation MicroLogix 1400
Display shows
UNSUPPORTED INSTRUCTION DETECTED (0031)
Type
Error code
Source
Manual p. 403

What 0031 means

UNSUPPORTED INSTRUCTION DETECTED p. 403

Common causes

  • The program contains an instruction that the controller does not support. p. 403

What to do

  1. ['Modify the program so that the controller supports all instructions.', 'Recompile and reload the program and enter the Run mode.'] p. 403

Before you service the product, read the safety instructions in the manual p. 274.

If 0031 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 0031; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.