Rockwell Automation MicroLogix 1400 Error 0032: S00/S0C/SOL OUTSIDE OF DATA FILE SPACE

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code0032

A sequencer instruction length/position parameter references outside of the entire data file space. The manual's first action is: “['Correct the program to ensure that the length and position parameters do not point outside the data file space.', 'Recompile, reload the program, and enter the Run mode.']”

Model
Rockwell Automation MicroLogix 1400
Display shows
S00/S0C/SOL OUTSIDE OF DATA FILE SPACE (0032)
Type
Error code
Source
Manual p. 403

What 0032 means

S00/S0C/SOL OUTSIDE OF DATA FILE SPACE p. 403

Common causes

  • A sequencer instruction length/position parameter references outside of the entire data file space. p. 403

What to do

  1. ['Correct the program to ensure that the length and position parameters do not point outside the data file space.', 'Recompile, reload the program, and enter the Run mode.'] p. 403

Before you service the product, read the safety instructions in the manual p. 274.

If 0032 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 0032; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.