Rockwell Automation MicroLogix 1400 Error 002B: DNP3 EVENTS CONFIGURATION MISMATCH

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code002B

DNP3 event configuration (S:36/11) bit in the latest downloaded by user project differs from the power-up configuration. The manual's first action is: “['Cycle power for the new DNP3 configuration to take effect and enter the Run mode.']”

Model
Rockwell Automation MicroLogix 1400
Display shows
DNP3 EVENTS CONFIGURATION MISMATCH (002B)
Type
Error code
Source
Manual p. 403

What 002B means

DNP3 EVENTS CONFIGURATION MISMATCH p. 403

Common causes

  • DNP3 event configuration (S:36/11) bit in the latest downloaded by user project differs from the power-up configuration. p. 403

What to do

  1. ['Cycle power for the new DNP3 configuration to take effect and enter the Run mode.'] p. 403

Before you service the product, read the safety instructions in the manual p. 274.

If 002B is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 002B; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.