Rockwell Automation MicroLogix 1400 Error 0035: ILLEGAL INSTRUCTION IN INTERRUPT FILE

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code0035

The program contains a Temporary End (TND), Refresh (REF), or Service Communication Instruction in an interrupt subroutine (STI, EII, HSC) or user fault routine. The manual's first action is: “['Correct the program.', 'Recompile, reload the program, and enter the Run mode.']”

Model
Rockwell Automation MicroLogix 1400
Display shows
ILLEGAL INSTRUCTION IN INTERRUPT FILE (0035)
Type
Error code
Source
Manual p. 403

What 0035 means

ILLEGAL INSTRUCTION IN INTERRUPT FILE p. 403

Common causes

  • The program contains a Temporary End (TND), Refresh (REF), or Service Communication Instruction in an interrupt subroutine (STI, EII, HSC) or user fault routine. p. 403

What to do

  1. ['Correct the program.', 'Recompile, reload the program, and enter the Run mode.'] p. 403

Before you service the product, read the safety instructions in the manual p. 274.

If 0035 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 0035; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.