Rockwell Automation MicroLogix 1400 Error 0034: NEGATIVE VALUE IN TIMER PRESET OR ACCUMULATOR

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code0034

A negative value was loaded to a timer preset or accumulator. The manual's first action is: “['If the program is moving values to these accumulated or preset word of a timer, verify these values are not negative.', 'Reload the program and enter the Run mode.']”

Model
Rockwell Automation MicroLogix 1400
Display shows
NEGATIVE VALUE IN TIMER PRESET OR ACCUMULATOR (0034)
Type
Error code
Source
Manual p. 403

What 0034 means

NEGATIVE VALUE IN TIMER PRESET OR ACCUMULATOR p. 403

Common causes

  • A negative value was loaded to a timer preset or accumulator. p. 403

What to do

  1. ['If the program is moving values to these accumulated or preset word of a timer, verify these values are not negative.', 'Reload the program and enter the Run mode.'] p. 403

Before you service the product, read the safety instructions in the manual p. 274.

If 0034 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 0034; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.