Rockwell Automation MicroLogix 1400 Error 0003: MEMORY MODULE USER PROGRAM IS CORRUPT

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code0003

Memory module memory error occurred, possibly during a run mode transition. The manual's first action is: “Reprogram the memory module. If the error persists, replace the memory module.”

Model
Rockwell Automation MicroLogix 1400
Display shows
MEMORY MODULE USER PROGRAM IS CORRUPT (0003)
Type
Error code
Source
Manual p. 402

What 0003 means

MEMORY MODULE USER PROGRAM IS CORRUPT p. 402

Common causes

  • Memory module memory error. This error can also occur when going to the Run mode., p. 402

What to do

  1. Reprogram the memory module. If the error persists, replace the memory module. p. 402

Before you service the product, read the safety instructions in the manual p. 274.

If 0003 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 0003; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.