Rockwell Automation MicroLogix 1400 Error 0002: UNEXPECTED RESET

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code0002

Controller was unexpectedly reset due to noise or hardware failure, and the default program is loaded. The manual's first action is: “• See proper grounding guidelines and using surge suppressors in your controller User Manual. • Verify that the battery is connected. • Contact your local Rockwell Automation representative if the error persists.”

Model
Rockwell Automation MicroLogix 1400
Display shows
UNEXPECTED RESET (0002)
Type
Error code
Source
Manual p. 402

What 0002 means

UNEXPECTED RESET p. 402

Common causes

  • The controller was unexpectedly reset due to a noisy environment or internal hardware failure., The default program is loaded. p. 402

What to do

  1. • See proper grounding guidelines and using surge suppressors in your controller User Manual. • Verify that the battery is connected. • Contact your local Rockwell Automation representative if the error persists. p. 402

Before you service the product, read the safety instructions in the manual p. 274.

If 0002 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 0002; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.