Rockwell Automation MicroLogix 1400 Error 0004: MEMORY INTEGRITY ERROR

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code0004

ROM or RAM became corrupted during power-up or a background integrity check failed. The manual's first action is: “• Cycle power on your controller. Then, redownload your program and start up your system. • See proper grounding guidelines and using surge suppressors in your controller User Manual. • Contact your local Rockwell Automation representative if the error persists.”

Model
Rockwell Automation MicroLogix 1400
Display shows
MEMORY INTEGRITY ERROR (0004)
Type
Error code
Source
Manual p. 402

What 0004 means

MEMORY INTEGRITY ERROR p. 402

Common causes

  • While the controller was powered up, ROM or RAM became corrupted or when a background integrity check failed. p. 402

What to do

  1. • Cycle power on your controller. Then, redownload your program and start up your system. • See proper grounding guidelines and using surge suppressors in your controller User Manual. • Contact your local Rockwell Automation representative if the error persists. p. 402

Before you service the product, read the safety instructions in the manual p. 274.

If 0004 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 0004; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.