Rockwell Automation MicroLogix 1400 Error 0008: FATAL INTERNAL SOFTWARE ERROR

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code0008

Fatal internal software error occurred unexpectedly. The manual's first action is: “• Cycle power on your controller. Then, redownload your program and reinitialize any necessary data. • Start up your system. • See proper grounding guidelines and using surge suppressors in your controller User Manual. • Contact your local Rockwell Automation representative if the error persists.”

Model
Rockwell Automation MicroLogix 1400
Display shows
FATAL INTERNAL SOFTWARE ERROR (0008)
Type
Error code
Source
Manual p. 402

What 0008 means

FATAL INTERNAL SOFTWARE ERROR p. 402

Common causes

  • An unexpected software error occurred. p. 402

What to do

  1. • Cycle power on your controller. Then, redownload your program and reinitialize any necessary data. • Start up your system. • See proper grounding guidelines and using surge suppressors in your controller User Manual. • Contact your local Rockwell Automation representative if the error persists. p. 402

Before you service the product, read the safety instructions in the manual p. 274.

If 0008 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 0008; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.