Rockwell Automation MicroLogix 1400 Error 0001: NVRAM ERROR

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code0001

NVRAM error occurred because the default program was loaded after a power-down or RAM integrity test failed. The manual's first action is: “• Redownload or transfer the program. • Verify that the battery is connected. • Contact your local Rockwell Automation representative if the error persists.”

Model
Rockwell Automation MicroLogix 1400
Display shows
NVRAM ERROR (0001)
Type
Error code
Source
Manual p. 402

What 0001 means

NVRAM ERROR p. 402

Common causes

  • The default program is loaded to the controller memory. This occurs: • if a power down occurred during program download or transfer from the memory module., • RAM integrity test failed. p. 402

What to do

  1. • Redownload or transfer the program. • Verify that the battery is connected. • Contact your local Rockwell Automation representative if the error persists. p. 402

Before you service the product, read the safety instructions in the manual p. 274.

If 0001 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 0001; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.