Rockwell Automation MicroLogix 1400 Error 28: SOCKET_ERROR_UNBIND

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code28

Code 28 means a socket error occurred during the Unbind operation. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
SOCKET_ERROR_UNBIND (28)
Type
Error code
Source
Manual p. 354

What 28 means

SOCKET_ERROR_UNBIND p. 354

Common causes

  • Socket error during Unbind operation. p. 354

If 28 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 28; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.