Rockwell Automation MicroLogix 1400 Error 0009: FATAL INTERNAL HARDWARE ERROR

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code0009

Fatal internal hardware error occurred unexpectedly. The manual's first action is: “• Cycle power on your controller. Then, redownload your program and reinitialize any necessary data. • Start up your system. • See proper grounding guidelines and using surge suppressors in your controller User Manual. • Contact your local Rockwell Automation representative if the error persists.”

Model
Rockwell Automation MicroLogix 1400
Display shows
FATAL INTERNAL HARDWARE ERROR (0009)
Type
Error code
Source
Manual p. 402

What 0009 means

FATAL INTERNAL HARDWARE ERROR p. 402

Common causes

  • An unexpected hardware error occurred. p. 402

What to do

  1. • Cycle power on your controller. Then, redownload your program and reinitialize any necessary data. • Start up your system. • See proper grounding guidelines and using surge suppressors in your controller User Manual. • Contact your local Rockwell Automation representative if the error persists. p. 402

Before you service the product, read the safety instructions in the manual p. 274.

If 0009 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 0009; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.