Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The ribbon or label is near its end. The manual lists no action for this code.
No error occurred. The manual lists no action for this code.
All 32 error codes of the SATO S84-ex / S86-ex SATO S84-ex / S86-ex printer with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
VMEXIT_NPF indicates a host-level page fault occurred during nested paging, with error details in EXITINFO1 and EXITINFO2. The manual lists no action for this code.
SETSSBSY indicates an invalid supervisor shadow stack token encountered by a SETSSBSY instruction. The manual lists no action for this code.
RSTORSSP indicates an invalid shadow stack restore token encountered by an RSTORSSP instruction. The manual lists no action for this code.
FAR-RET/IRET indicates a return address mismatch encountered by a far RET or IRET instruction. The manual lists no action for this code.
NEAR-RET indicates a return address mismatch encountered by a near RET instruction. The manual lists no action for this code.
All 5 error codes of the AMD AMD64 Technology AMD AMD64 Technology with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
The power unit experienced an internal software error with specific fault source information provided via r0949 decimal value. The manual lists no action for this code.
The power unit encountered an I2C bus error communicating with an EEPROM or analog/digital converter, indicating a module fault. The manual's first action is: “- internal software error.”
The power unit experienced an internal software error, flagged for internal Siemens troubleshooting only. The manual's first action is: “- replace power unit.”
The power unit detected a watchdog timer overflow during boot, indicating a previous reset caused by SAC timing issues. The manual's first action is: “- carry out a POWER ON (switch-off/switch-on) for all components.”
The power unit detected an invalid switching information end ID in the setpoint telegram for a 3P gating unit. The manual's first action is: “- carry out a POWER ON (switch-off/switch-on) for all components.”
Internal parameter data in the EEPROM is corrupted, and the module must be replaced to restore functionality. The manual's first action is: “- Replace the module.”