Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
An internal data error has occurred in the system, displaying code Er6. The manual lists no action for this code.
An internal data error has occurred in the system, displaying code Er4. The manual lists no action for this code.
The applied pressure falls below the set low limit of the pressure range, triggering a pressurizing error. The manual's first action is: “Reset applied pressure to a level within the set pressure range.”
The applied pressure exceeds the set high limit of the pressure range, triggering a pressurizing error. The manual's first action is: “Reset applied pressure to a level within the set pressure range.”
During zero clear operation, pressure was applied outside ±10%F.S., causing a residual pressure error that resets after three seconds. The manual's first action is: “Perform zero-clear operation again after restoring …
The switch output is drawing 80mA or more of load current, indicating an overcurrent condition. The manual's first action is: “Turn off the power and remove the output factor. Then turn the power on.”
All 8 error codes of the SMC ISE35 TFJ33GB-A digital pressure switch with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
The cache test has failed on the Dell T3500. The manual lists no action for this code.
Super I/O chip failure means the integrated input/output controller is not functioning properly. The manual lists no action for this code.
Time-Of-Day Clock test in progress or failure suggests an issue with the system clock hardware. The manual lists no action for this code.
Interval Timer Channel 2 test in progress or failure indicates a problem with timer channel 2 functionality. The manual lists no action for this code.
No memory in Bank 0 means no RAM was detected in the first memory bank. The manual lists no action for this code.
RAM test in progress or failure above address 0FFFFh indicates a memory check error beyond the 64KB limit. The manual lists no action for this code.
Unexpected interrupt in Protected Mode suggests an internal system interruption during protected mode execution. The manual lists no action for this code.
1st 64 K RAM chip or data line failure - bit D indicates a specific bit-level error in the first 64 KB of RAM. The manual lists no action for this code.