Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
An NC memory access error happens when the MLC fails to access the NC memory. The manual's first action is: “Restart the CNC controller or send it back for servicing.”
An NC channel error occurs when the G code line number is illegal in the machining program. The manual's first action is: “Check the machining program.”
A Remote I/O error happens due to a problem with the remote I/O connection or board. The manual's first action is: “1. Check the remote I/O connection or replace the remote I/O board.”
A servo error occurs when an alarm signal is triggered on the pulse card, or excessive pulses are generated, or there's a pulse leakage issue. The manual's first action is: “Check the error cause of the connected drive.”
All 171 error codes of the Delta IA-CNC_Milling CNC milling machine with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
Parameter length is shorter than the required minimum size. The manual lists no action for this code.
Parameter length exceeds the maximum allowed size. The manual lists no action for this code.
Parameter value is outside the allowed range. The manual lists no action for this code.
Access denied due to permission restrictions. The manual lists no action for this code.
Subindex not available for the requested parameter. The manual lists no action for this code.
Index not available for this device. The manual lists no action for this code.
All 6 error codes of the Balluff BSP B/M/V pressure sensor with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
High temperature alarm indicates overheating, which may be caused by fan failure, a dirty condenser, blocked air channels, or excessive heat load. The manual's first action is: “Make sure internal fan and external fan…
Cabinet door open alarm triggers when the door switch is malfunctioning or the connection is loose. The manual's first action is: “Make sure the connection is not loose ; Make sure the connection is correct.”
Sensor 1 error occurs when the Pb1 sensor is faulty or its connection cable is improperly connected. The manual's first action is: “Check the connection cable; Make sure the connection is correct.”