Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The specified socket (connection) is already open or is being closed. The manual lists no action for this code.
Non-zero bit address specified for the results storage area. The manual lists no action for this code.
The variable type for the results storage area is out of range. The manual lists no action for this code.
TCP socket number is out of range or remote IP/port is 0. The manual lists no action for this code.
The command sent is too small or contains no data. The manual lists no action for this code.
The command sent to the system exceeds its maximum allowed size. The manual lists no action for this code.
CPU Unit error, execution not possible. The manual lists no action for this code.
The system detected an error in the local IP address setting. The manual's first action is: “Set the IP address correctly.”
The system is operating normally. The manual lists no action for this code.
All 66 error codes of the Omron CS1W-ETN21, CJ1W-ETN21 Omron CS1W-ETN21, CJ1W-ETN21 with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
The remote AIR probe has not been connected or wired incorrectly, or is faulty. The manual lists no action for this code.
The remote FLOOR probe has not been connected or wired incorrectly, or is faulty. The manual lists no action for this code.
The internal sensor has developed a fault. The manual lists no action for this code.
All 3 error codes of the Heatmiser neoStat Series Heatmiser neoStat Series with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
Motor or controller has short circuit Abnormality The manual lists no action for this code.