Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The offset value specified by T code is too big. The manual's first action is: “Perform tool setting again, modify the offset value specified by T code.”
In circular interpolation, R and (K,I) are zero. The manual's first action is: “Specify radius of circle correctly when checking program.”
In circular interpolation, R and (K,I) are specified simultaneously. The manual's first action is: “Either R or (K,I) is used to specify radius of circular arc. Delete unneeded characters.”
The value specified in circular interpolation can not form a circular arc. The manual's first action is: “Modify program, radius, starting coordinate value or ending coordinate values of the circular arc.”
Radius of circular interpolation is too big. The manual's first action is: “Modify radius R. See programming manual.”
Circular interpolation radius R is defined as a negative value. The manual's first action is: “Circular radius R should not be a negative value, modify the program.”
The zero return block is at the edge of the block or factory settings cannot be covered. The manual's first action is: “zero return. Adjust position of zero return block, and perform zero return again.”
All 105 error codes of the GSK GSK980TB3 GSK GSK980TB3 with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
DSP address bus and memory cell error detected. The manual lists no action for this code.
DSP data bus error occurred, with six-digit hex code indicating which of the 24 data lines are faulty The manual lists no action for this code.
DSP not responding. The instrument must be power cycled. The manual lists no action for this code.
All 3 error codes of the Stanford Research Systems DS360 DS360 Ultra Low Distortion Function Generator with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
The calibration value set does not match the actual signal being measured. The manual lists no action for this code.
The calibration value entered is invalid for the current measurement function and range. The manual lists no action for this code.
Calibration was aborted due to instrument shutdown or bus Device Clear. The manual lists no action for this code.