Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The spindle will not start if the chuck is not clamped. The manual lists no action for this code.
Data input exceeds the allowable range. The manual's first action is: “Modify data or check whether the destination address value exceeds the range.”
In the process of tool nose radius compensation, G code is specified repeatedly in circular arc command. The manual's first action is: “Modify the program. See programming manual for details.”
Excessive cutting will occur in tool nose radius compensation The manual's first action is: “Check the program. See programming manual for details.”
Illegal command appears in the process of tool compensation. The manual's first action is: “Check the program. See programming manual for details.”
Continuous display of non-moving G Codes during tool compensation process. The manual's first action is: “Delete unneeded blocks.”
Excessive cutting occurs when circular arc start or end point matches center point during tool nose radius compensation. The manual's first action is: “Modify the program”
Block is non-moving G Code when compensation starts. The manual's first action is: “Block shall not be non-moving G Code when compensation starts.”
Tool radius compensation is performed before tool offset number is specified. The manual's first action is: “Tool offset number shall be specified before executing tool compensation. Modify program, e.g. Add T0101.”
Compensation direction of the next block changes after compensation is started. The manual's first action is: “Tool compensation direction shall not be changed after the compensation is started. Modify the program.”
Tool radius compensation cannot be started or canceled using G2 or G3. The manual's first action is: “G2 or G3 can not be performed when starting or canceling the tool compensation. Modify the program.”
There is no cross point in tool nose radius compensation The manual's first action is: “Modify the program”
Communication error occurs when CNC baud rate does not match computer baud rate The manual's first action is: “Check whether the baud rate of CNC is consistent with that of the computer”
The file can not be found The manual's first action is: “Search the file again”
Tool offset number exceeds the range of 1-64. The manual's first action is: “Modify tool offset number, the range: 1-64”