Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Furnes probe has exceeded its maximum temperature limit. The manual's first action is: “Block”
Difference in temperature between return and delivery probes is faulty. The manual's first action is: “Block”
Return water temperature is too high. The manual's first action is: “Block”
Low temperature thermostat or condensate pump safety device has failed. The manual's first action is: “Block”
Limit thermostat has failed. The manual's first action is: “Block”
Ignition attempts finished because no flame or condensate is present. The manual's first action is: “Block”
All 16 error codes of the Residence 35 KIS e condensing boiler with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
ECU Fail happens when the module fails to detect any data from the ECU. The manual's first action is: “it will initiate a shutdown alarm.”
ECU Shutdown occurs when an error message is received from the ECU via J1939. The manual's first action is: “it will initiate a shutdown alarm.”
Over Power triggers when the detected power exceeds the pre-set limit, if over power detection is enabled. The manual's first action is: “the controller will initiate a shutdown alarm.”
Input Shutdown happens when an external input signal becomes active. The manual's first action is: “the controller will send a shutdown alarm signal and it will be displayed on the LCD.”
Maintenance shutdown occurs when the genset has run longer than the user-set maintenance time and shutdown is selected as the action. The manual's first action is: “the controller send a shutdown alarm signal and it w…
All 5 error codes of the Woodward easYgen-1400 easYgen-1400 genset control with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
The slot where the module is installed is invalid or not available. The manual's first action is: “Check the station to determine if the module is plugged in or pulled.”
The length of the data record entered is incorrect for the system. The manual's first action is: “Enter valid value for data record length.”