Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
M98,M99 or M30 is specified in blocks addressed by P or Q. The manual's first action is: “Modify the program and delete incorrect codes.”
In code G70, G71,G72,G73, in the blocks specified by P or Q, non-moving G Code or unusable G code is specified. The manual's first action is: “Modify the program. See programming manual for details.”
Error 065 occurs when G00 or G01 is not defined in the first block of a cycle, or when X/U or Z/W are not separately defined. The manual's first action is: “In the first block of NS~NF should be G00 or G01. In the fir…
Tool compensation cannot be used while executing certain G codes. The manual's first action is: “The above G codes can not be performed in tool compensation state. Execute G40 first.”
In G70, blocks specified by P or Q can not be found. The manual's first action is: “Modify the program, and add correct blocks.”
The program has an invalid cutting depth or negative value in a tool path command. The manual's first action is: “Modify the program. See programming manual.”
The finishing allowance is set to a negative value. The manual's first action is: “Range of finishing allowance: 0-9999.999 mm. Modify the program.”
#I or #K in G74 or G75 is a negative value. The manual's first action is: “Modify the program. See programming manual for details.”
053 on the GSK GSK980TB3 is listed in the manual as: P or Q value is not specified in G70,G71,G72,G73 code.. The manual's first action is: “Modify the program. See programming manual for details.”
Thread height or initial cutting depth specified in G76 is 0 or negative number. The manual's first action is: “Modify the program. See programming manual for details.”
In G76, minimum specified cutting depth or finishing allowance is bigger than thread height. The manual's first action is: “Modify the program, and specify a correct cutting depth. See programming manual for details.”
An unusable tool nose angle is specified in G76. The manual's first action is: “Modify the program, and specify a correct degree. See programming manual for details.”
Spindle CW (rotates negatively) is specified before stopping spindle CCW (rotates positively). The manual's first action is: “Perform M05, an then execute M03 or M04.”
Storage is wrong at power off. Please power on the CNC. The manual's first action is: “Cancel the alarm by pressing reset key, and power on again.”
The chuck releases when the spindle runs. The manual lists no action for this code.