Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The IGBT temperature is too high due to excessive motor load, high ambient temperature, or incorrect parameter settings. The manual's first action is: “Do a check of the parameter settings.”
An unknown device was connected to the power unit or option board. The manual's first action is: “The device is not available. If the fault occurs again, ask instructions from your nearest distributor.”
Device removed in Slot E. The manual lists no action for this code.
Device removed in Slot D. The manual lists no action for this code.
Device removed indicates that an option board was removed from slot C, same as ID380. The manual lists no action for this code.
Device removed occurs when an option board was taken out from slot A or B. The manual's first action is: “The device is not available. Reset the fault.”
Device added (same type) refers to an option board in slot E being added, same as ID372. The manual lists no action for this code.
Device added (same type) indicates an option board in slot D was installed, same as ID372. The manual lists no action for this code.
Device added (same type) refers to an option board in slot C being added, same as ID372. The manual lists no action for this code.
Device added (same type) occurs when an option board was installed into slot B previously used, ready for use. The manual's first action is: “The device is ready to be used. The drive starts to use the old parameter s…
Device changed (same type) refers to a replacement of an option board in slot E, same as ID362. The manual lists no action for this code.
Device changed (same type) indicates a replacement of an option board in slot D, same as ID362. The manual lists no action for this code.
Device changed (same type) refers to a replacement of an option board in slot C, same as ID362. The manual lists no action for this code.
Device changed (same type) means an option board in slot B was replaced with one previously used, ready for use. The manual's first action is: “Reset the fault. The drive starts to use the old parameter settings.”
Device changed (same type) indicates that a new power unit of same size was installed and parameters are now available. The manual's first action is: “Reset the fault. The drive reboots after you reset the fault.”