Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
PLC model unmatch error because the transfer program does not match the destination PLC model. The manual's first action is: “Check if the PLC program for transfer matches the destination PLC.”
SD memory card recognition error because the SD card cannot be detected by the system. The manual's first action is: “Check the SD memory card used.”
SD memory card saved file name error when file name is not specified properly for saving. The manual's first action is: “Specify the file name properly.”
SD memory card reading error because saved data on the card may be damaged. The manual's first action is: “Check whether the saved data in the SD memory card is not damaged with a PC.”
SD memory card memory full due to exhausted storage space. The manual's first action is: “Delete some data in the SD memory card or prepare a new SD memory card.”
SD memory card writing error because the card is write-protected. The manual's first action is: “Check whether the SD memory card is not write-protected.”
SD memory card not inserted properly into the SD memory card slot. The manual's first action is: “Check the SD memory card slot.”
Tool setting error due to specifying an unusable device in the data. The manual's first action is: “Check if the used device is correct. (e.g. the word device is set in the bit area.)”
Alarm history error because alarm history display update was stopped, but memory still holds updated data. The manual's first action is: “Once the stop of display update is cancelled, new data is displayed.”
Keyboard screen data parts digit error when the displayed digit on keyboard screen is incorrectly set. The manual's first action is: “Check if the digit of the data parts on the keyboard screen has been set correctly.”
Time up error caused by disconnected PLC connection cable or temporary noise interference. The manual's first action is: “Check the connection cable to make sure it is connected.”
Overrun error because the GT or CPU unit reception buffer is overflowing. The manual's first action is: “There could be an error in the PLC.”
Data error due to errors in communication condition settings or temporary noise interference. The manual's first action is: “Check the PLC and GT baud rate and transfer format.”
Time up error No response from the PLC. The manual's first action is: “Check the connection cable to make sure it is connected.”
An error has occurred in communication between the GT and an external device (e.g. PLC). The manual's first action is: “Refer to <5.3 Troubleshooting Error Codes>.”