Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
A defect exists in Slot A or its option board. The manual's first action is: “Do a check of the board and the slot. Ask instructions from your nearest distributor.”
The fieldbus connection between the master and board is defective. The manual's first action is: “Do a check of the installation and fieldbus master.”
The communication between the control panel and drive is defective. The manual's first action is: “Do a check of the control panel connection and the control panel cable if you have it.”
A user-specified digital input fault occurred as set by parameter P3.5.1.11 or P3.5.1.12. The manual's first action is: “This is a user-specified fault. Do a check of the digital inputs and schematics.”
One or more analogue input signals are below 50% of the minimum signal range due to a defective cable, loose connection, or malfunctioning source. The manual's first action is: “Replace the defective parts. Do a check…
The drive software has been updated, requiring no action. The manual's first action is: “No steps are necessary.”
The Real Time Clock battery voltage is low. The manual's first action is: “Replace the battery.”
An option board in Slot E was installed that you have not used before in the same slot. The manual lists no action for this code.
An option board in Slot D was installed that you have not used before in the same slot. The manual lists no action for this code.
An option board in Slot C was installed that you have not used before in the same slot. The manual's first action is: “Set the option board parameters again.”
A new power unit of a different type has been installed and parameters are not available. The manual's first action is: “Reset the fault. The drive reboots after you reset the fault. Set the power unit parameters again.”
An option board in Slot E was replaced with an unconfigured one. The manual lists no action for this code.
An option board in Slot D was replaced with an unconfigured one. The manual lists no action for this code.
An option board in Slot C was replaced with an unconfigured one. The manual's first action is: “Reset the fault. Set the option board parameters again.”
A new power unit of a different type has been installed and parameters are not available. The manual's first action is: “Reset the fault. The drive reboots after you reset the fault. Set the power unit parameters again.”