Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Connected GT designation area error occurs when the bit corresponding to the station number of the connected GT is not on in the designated area. The manual's first action is: “Check the connected GT designation area.”
Start time device value error occurs when the value at the start of the line graph function is out of the allowed setting range. The manual's first action is: “Check the setting value.”
Index register value error occurs when the device value for index modifier is outside the allowed setting range. The manual's first action is: “Check the setting value.”
All data must be transferred because the record area for logging cannot be reserved in SRAM. The manual's first action is: “Transfer all data.”
Writing to the SD memory card is disabled by a setting that prevents it from being written to. The manual's first action is: “Cancel the writing stop setting.”
Writing to the SD memory card is disabled by a setting that prevents it from being written to. The manual's first action is: “Cancel the writing stop setting.”
The SD memory card's storage capacity has been exhausted, requiring data deletion or a new card. The manual's first action is: “Delete some data in the SD memory card or prepare a new SD memory card.”
Data cannot be written into the SD memory card because it is write-protected or the record area for logging was overwritten. The manual lists no action for this code.
A SD memory card is not inserted, causing the system to detect its absence. The manual's first action is: “Check the SD memory card slot.”
Forced operation error occurs when a device that cannot be forcibly operated in PROG. mode has been turned on or off forcibly. The manual lists no action for this code.
Remote mode error because the PLC (FP2/FP2SH) is set to RUN mode instead of REMOTE or PROG. mode. The manual's first action is: “Change to the REMOTE mode or PROG. mode.”
General-purpose memory shortage in the destination PLC, causing insufficient memory for operation. The manual lists no action for this code.
Master memory installation error because a master memory is installed in the PLC (FP-X), preventing program transfer from SD card. The manual lists no action for this code.
Password protection error due to incorrect password input, upload protection set on PLC, or digit change during new password setup. The manual's first action is: “Input the correct password after turning the power sup…
PLC model unsupported error when an unsupported PLC model is selected for operation. The manual's first action is: “Confirm the PLC model.”