Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
CURRENT SENSE FAULT ※ occurs due to a short in the motor or its wiring, or controller failure. The manual lists no action for this code.
HPD FAULT occurs from improper sequence of throttle, KSI, push, or inhibit inputs, or misadjusted throttle pot. The manual lists no action for this code.
BRAKE OFF FAULT happens if the electromagnetic brake driver is open or the brake coil is shorted. The manual lists no action for this code.
PRECHARGE FAULT ※ occurs when the brake driver is shorted, precharge circuit is damaged, or a MOSFET has failed. The manual lists no action for this code.
BRAKE ON FAULT is triggered if the electromagnetic brake driver is shorted or the brake coil is open. The manual lists no action for this code.
WIRING FAULT ※ occurs due to misadjusted throttle, broken throttle pot, or defective throttle mechanism. The manual lists no action for this code.
MAIN ON FAULT happens if the main contactor driver fails to close properly. The manual lists no action for this code.
MAIN FAULT ※ occurs when the main contactor is welded or stuck open, or its driver has failed. The manual lists no action for this code.
MAIN OFF FAULT indicates that the main contactor is welded or stuck open, or its driver has failed. The manual lists no action for this code.
OVER VOLTAGE FAULT appears if battery voltage exceeds 31 volts, the vehicle is charging with a charger attached, or there’s an intermittent battery connection. The manual lists no action for this code.
UNDER VOLTAGE FAULT occurs when battery voltage drops below 17 volts or there's a bad connection at the battery or controller. The manual lists no action for this code.
SPEED POT FAULT is triggered when the speed limit pot’s wiring is broken or shorted, or if the pot itself is damaged. The manual lists no action for this code.
THROTTLE FAULT happens due to an open or shorted throttle input wire, a defective throttle pot, or incorrect throttle type selection. The manual lists no action for this code.
THERMAL FAULT occurs when temperature exceeds 80°C or falls below -10°C, or if the vehicle is under excessive load or in extreme environments. The manual lists no action for this code.
All 15 error codes of the Jaguar VR28023 86014 scrubber with their meaning, causes and what to do, taken from the manufacturer's manual with page references.